Installing/removing spur center, Installing/removing live center – Grizzly G0658 User Manual

Page 25

Advertising
background image

Models G0657/G0658 (Mfg. Since 5/13)

-23-

installing/Removing

Spur Center

the spur center installs into the headstock spin-
dle with a taper fit.

To install the spur center:

1. disConneCt lathe FroM poWer!

2. insert the tapered end of the center into the

spindle, and push it in quickly and firmly
(

figure 24).

3. Check that the center is securely installed

by giving it a quick tug. (a properly installed
center will not pull out by hand.)

To remove the spur center:

1. disConneCt lathe FroM poWer!

2. insert the knockout rod into the outboard

end of the spindle. use a shop rag or wear a
glove to catch the center and gently tap the
rod handle until the spur center is freed from
the spindle (

figure 25).

figure 24. inserting spur center into spindle.

headstock

spindle Wheel

spur Center

4. tighten the quill lock handle.

installing/Removing

Live Center

Quill lock handle

Quill

handwheel

Quill

live Center

figure 26. live center installed in tailstock.

spur Center

headstock

spindle Wheel

figure 25. removing spur center.

Knockout bar

To install the live center:

1. loosen the quill lock handle (if locked)

approximately half a turn counterclockwise.

2. rotate the quill handwheel clockwise until the

quill protrudes about 3/4".

3. insert the live center, as shown in figure 26,

and push firmly.

Advertising
This manual is related to the following products: