Grizzly G0658 - Manual (Page 37)

Models G0657/G0658 (Mfg. Since 5/13)
-35-
To remove the old belt:
1. disConneCt lathe FroM poWer!
2. release belt tension as described in
Changing Speed Ranges on Page 21, then
remove the belt from the lower pulley.
3. loosen both set screws on the spindle
handwheel ( figure 51), and turn it clockwise
to unthread and remove it.
Changing Belt
4. loosen the set screw on the spindle pulley
and both lock collars (refer to figure 51 for
set screw locations).
5. tap the spindle far enough out of the head-
stock that the belt can be removed. a rubber
or wooden mallet may be required. take care
not to damage the spindle threads or to lose
parts in the process (
figure 52).
To install new belt:
1. place the new belt over the spindle pulley.
2. slide the spindle back through the headstock
and into the original position. a mallet may be
required.
3. install the headlock spindle handwheel and
tighten both set screws.
4. loosely install the belt on the motor pulley in
the inner or outermost position.
5. adjust the spindle pulley position on the
spindle shaft to ensure proper belt alignment
(
figure 53), then tighten the pulley set screw.
6. position the spindle rpM sensor ring in-line
with the rpM sensor. slide the lock collars
snug against each side of the sensor ring,
then tighten the set screws (
figure 54).
figure 53. proper belt alignment.
Correct alignment
incorrect
alignment figure 51 set screw locations.
figure 52. belt removal.
figure 54. rpM sensor.
7. Complete the new belt installation by fol-
lowing Steps 6-9 in the Changing Speed
Ranges procedure on Page 21.
spindle handwheel
lock Collars
spindle pulley
lock Collars
rpM sensor ring
rpM sensor