Grizzly G1012 - Manual (Page 14)

-12- G1012 18" Bandsaw
SECTION 4: ASSEMBLY
Keep loose clothing out
of the way of machinery
and keep hair pulled
back, or serious injury
may occur.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.
We have organized the assembly process of the
Model G1012 into steps listed below. Please fol-
low them in sequence. The inventory photos and
lists, hardware recognition chart, parts list and
exploded diagram have been provided to make
assembly as easy as possible.
1. Stand
2. Motor
3.
Mounting Unit to Stand
4. Wiring
5.
Pulley Alignment
6. Table
7. Fence Assembly
8. Total Unit Check
Order of Assembly
NOTICE
TOOLS REQUIRED: In addition to the tools
provided with your bandsaw, you will need a
metric set of wrenches, large and medium
flat-tipped screwdrivers, a Phillips
® screw-
driver, and a 6" or 8" adjustable wrench.
To begin the stand assembly, locate all the stand
parts so they are within easy reach.
1. Flip the stand top upside down. Install the
two adjustment bolts on the stand top by
placing the
3 ⁄
8
"-16 x 1 1 ⁄
4
" carriage bolts
through the mounts on the stand top and
then the through eyes of the adjustment
bolts. Secure with
3 ⁄
8
" washers and hex nuts,
but do not completely tighten.
2. Using (2) 3 ⁄
8
"-16 x 3 ⁄
4
" carriage bolts, wash-
ers, and hex nuts; attach the motor bracket
to the mounts on the stand top without tight-
ening.
3. Place a 3 ⁄
8
"-16 hex nut and washer on each
adjustment bolt, then rotate the motor brack-
et over the adjustment bolts, and secure with
another
3 ⁄
8
"-16 hex nut and washer so your
assembly looks like Figure 5. Again, do not
completely tighten at this time.
Stand