Grizzly G1012 - Manual (Page 21)

G1012 18" Bandsaw -19-
The last item to install is the rip fence. Notice on
the front and back edge of the table there are (4)
1 ⁄
4
" threaded holes. These holes accept the cap
screws that secure the fence rails to the table.
This assembly is illustrated in
Figure 24.
1. Attach the rear fence rail to the table with the
(4)
1 ⁄
2
" - 20 x 2" cap screws and spacers pro-
vided.
2. If you wish to mount the fence to the left of
the blade, the fence must be mounted to the
front rail before it is attached to the table.
Otherwise, you will need to remove the
blade to slide the fence over.
3. Secure the mounting bolts and ensure that
the fence slides easily on the rails. Apply a
shot of light oil or silicone spray to each rail
for better movement. To remove the fence
from the table, reverse
steps 1-3.
To install the upper and lower blade guides:
1. Locate the eight blade guides from your
hardware bags. Insert the blade guides in
the holes that face the bandsaw blade.
2. Secure the blade guides by screwing the
thumbscrews into the threaded holes that
intersect the blade guides as shown in
Figure 23.
Figure 24. Attachment of fence rail to the table.
Table
Spacer
1/4" - 20 x 1 1 ⁄
2
" Socket
Head Cap Screw
Fence
Blade Guides
Rail
This concludes assembly of the bandsaw.
Please DO NOT operate this saw until you
have read and have followed the safety
information, adjustment and operation sec-
tions in this manual. Operation without
complete knowledge of this machine could
lead to serious operator injury or damage to
the machine or workshop.
Figure 22. Inserting roll pin in table.
7. Install the table insert in the center of the
table. Rotate the table insert so the notch in
the insert lines up with the notch in the table
to form a small hole. Locate the roll pin from
your hardware bags and tap it into this small
hole as shown in
Figure 22.
Thumbscrew
Blade Guides
Figure 23. Blade guide assembly.