Grizzly G1012 - Manual (Page 31)

G1012 18" Bandsaw -29-
Once the assembly is complete and the adjust-
ments are done to your satisfaction, you are
ready to test the machine.
Turn on the power supply at the main panel. Pull
the paddle switch up to start the bandsaw. Make
sure that your hand is poised over the switch in
case there is a problem. The bandsaw should run
smoothly with little or no vibration or rubbing nois-
es. Strange or unnatural noises should be inves-
tigated and corrected before operating the
machine further.
If you cannot easily locate the source of an
unusual noise or vibration, feel free to contact our
service department for help.
Test Run
SECTION 6: OPERATIONS
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire operation
process. Failure to com-
ply may result in serious
personal injury.
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.
Overview
The bandsaw is one of the most versatile wood
cutting tools in the shop. It is capable of perform-
ing many different cutting functions including, but
not limited to:
STRAIGHT CUTS
•
Miters
• Angles
• Compound Angles
• Resawing
• Ripping
• Crosscutting
IRREGULAR CUTS
•
Simple and Complex Curves
• Duplicate Parts
• Circles
• Beveled Curves
NOTICE
The following section was designed to give
instructions on the basic operations of this
bandsaw. However, it is in no way compre-
hensive of every bandsaw application. There
are many different jigs that can be built to
increase safety, accuracy, and types of cuts.
WE STRONGLY RECOMMEND that you read
books, trade magazines, or get formal train-
ing to maximize the potential of your
machine.
Using this machine pro-
duces sawdust which may
cause allergic reactions
and respiratory problems.
Use an approved dust
mask to protect yourself
from these hazards!