Grizzly G1012 - Manual (Page 16)

-14- G1012 18" Bandsaw
10. Flip the stand upright and adjust it back and
forth so it is level and symmetrical on the
legs. Now, tighten all of the stand bolts
(except the last stand side if you left it off) to
secure the bandsaw unit in place.
At this point, place the bandsaw on the stand.
Ensure that the bandsaw pulley shaft is posi-
tioned over the rectangular hole in the stand.
When the bandsaw is positioned on the stand,
fasten it (as shown in
Figure 11) with the (4) 1 ⁄
2
"-
12 x 1 1 ⁄
2
" hex head bolts, washers and nuts pro-
vided. Tighten securely.
The Model G1012 can be awkward to handle
without assistance. The bandsaw unit is
also very unstable until it is permanently
mounted to the stand. Failure to use caution
during assembly could lead to serious per-
sonal injury.
Figure 11. Bandsaw unit mounted to stand.
Figure 9. Preparing rubber feet for installation.
Figure 10. Rubber foot installed.
8. Prepare the four rubber feet by placing the
5 ⁄
16
"-18 x 1" bolts through the rubber feet and
tightening the 5 ⁄
16
"-18 hex nuts as shown in
Figure 9.
9. Install each rubber foot on the bottom of
each leg. Thread on another
5 ⁄
16
"-18 hex nut
to tighten the rubber foot to the leg as shown
in
Figure 10.