GE DPGT750 - Manual (Page 10)

Summary Screen
www.GEAppliances.com
OPTIONS
END OF CYCLE SIGNAL
EXTENDED TUMBLE
DELAY START
OK
1 HOUR
About the
Drying
Options Touch the OPTIONS pad on the Touch Screen
to select drying options. After selecting any drying
options, press OK to save your setting.
Delay Start
Touch the DELAY START pad repeatedly to set a
delay time of up to 12 hours. The countdown time
will be shown in the display.
Extended Tumble
Minimizes wrinkles by adding approximately
20 minutes of no-heat tumbling after clothes are
dry. Touch EXTENDED TUMBLE to turn the
feature on or off. If set, the Extended Tumble time
will not be included in the cycle time shown in the
display. The dryer will signal for the first 6 minutes
during Extended Tumble.
End-of-Cycle Signal
Alerts you that the cycle is complete. The clothes
should be removed when the beeper goes off so
wrinkles won’t set in. Touch END OF CYCLE
SIGNAL
to select the volume or to turn the
beeper off. The new volume will be saved as the
default setting.
ADJUST TIME SETTINGS
EXTENDED TUMBLE
CYCLE TIME DELAY TIME
Adjusting the
Time Settings You can adjust the time setting for the dry cycle,
delay start and extended tumble times. Touch the
TIME
pad on the Summary Screen; then choose
the time you wish to adjust.
To change the dry cycle time, select CYCLE TIME;
then use the arrows to select more or less drying
time. If the Cycle Time is changed, the dryness
sensor will be turned off.
To change the delay start or extended tumble time,
select DELAY TIME or EXTENDED TUMBLE;
then follow the instructions in the About the
Drying Options section.
10
About the
Cycle Status
Screen
CYCLE STATUS CHANGE
SETTINGS
DRYING
:32
After you press START, a Cycle Status screen will
appear to indicate what cycle the dryer is in and
the time remaining in the cycle.
DRYING – The dryer is sensing the moisture level
of the load.
SENSING – The dryer is determining if the correct
dryness level has been reached.
COOL DOWN – The load is dry and may be
removed (the dryer will continue to blow cool air
for up to 5 minutes).
EXTENDED TUMBLE – The load is dry and may
be removed (the drum will continue to turn
without heat for up to 20 minutes).