GE DPGT750 - Manual (Page 35)

REMOVE FILLER PLUGS
Installation Instructions
35
REVERSING THE DOOR SWING (if desired)
Open the door and remove the filler plugs
opposite the hinges.
1
REMOVE DOOR
• With the door completely open, remove
the BOTTOM screw from each hinge on
the dryer face.
• Insert the screws about halfway into the
TOP holes, for each hinge, on the opposite
side (where you removed the filler plugs).
Apply firm pressure to get the screw
started in new holes.
2
• Loosen the TOP screw from each hinge
on the dryer face halfway. With one hand
holding the top of the door and the other
hand holding the bottom, remove the door
from the dryer by lifting it UP and OUT.
REMOVE HANDLE
Remove the screws holding the handle and
two spacers.
3
Rear of Door
REVERSE DOOR CATCH
Remove the door catch and filler plate. Install
them on opposite sides of the door.
4
Filler
Plate
Catch