Grizzly Gear-Head G9036 - Manual (Page 22)

-20-
Model g9036 Mfg. 7/08+
spindle speed levers
the spindle speed levers ( figure 14) control the
speed that the spindle rotates. the chart below
the levers indicates the different lever configura-
tions required to make the spindle rotate at vari-
ous speeds.
never move this lever while the
spindle is moving.
feed direction lever
the feed direction lever ( figure 14) controls
which direction the feed rod rotates when the
spindle lever is used. this allows you to change
feed directions without changing the direction of
spindle rotation.
never move this lever while the
spindle is moving. refer to page 35 for details of
how to use this lever for operations.
feed speed controls
these knobs and levers ( figure 14) control feed
speeds and leadscrew engagement for threading
and turning.
figure 15. Brake.
Brake
carriage handwheel
the carriage handwheel ( figure 16) moves
the carriage left or right along the bed. this
handwheel is used when setting up the machine
or when manual control is desired during turning
operations.
cross slide handwheel
the cross slide handwheel ( figure 16) moves
the cross slide toward and away from the work.
turning the dial clockwise moves the slide toward
the workpiece. the graduated dial can be adjust-
ed by holding the handwheel with one hand and
turning the dial with the other.
compound slide handwheel
the compound slide handwheel ( figure 16) con-
trols the position of the cutting tool relative to the
workpiece. this slide is adjustable to any angle
within its range. the graduated dial is adjustable
using the same method as the dial on the cross
slide. Angle adjustment is locked by hex nuts on
the base of the top slide.
figure 16. Carriage handwheel controls.
Cross slide
handwheel
Carriage
handwheel
Compound slide
handwheel
brake
the brake ( figure 15) physically stops the spin-
dle and cuts power to the motor when pressed
down.