Grizzly Gear-Head G9036 - Manual (Page 52)

-50-
Model g9036 Mfg. 7/08+
cross slide
backlash adjustment
figure 88. leadscrew nut.
leadscrew nut
Backlash Adjustment
Cap screw
4. tighten the backlash adjustment cap screw
shown in figure 88 in small increments.
5. test after each adjustment by rotating the
handwheel back-and-forth until the backlash
amount is acceptable.
6. Feed the leadscrew nut back under the cross
slide and replace the cap screw removed in
step 2.
Backlash is the amount of play in a lead screw. it
is felt when turning a handwheel in one direction,
then turning it in the other direction. the distance
that the handwheel moves without moving the
leadscrew or attached components is the back-
lash.
When adjusting backlash, tighten the components
enough to remove backlash, but not so much that
the components bind the leadscrew, making it
hard to turn. overtightening will cause excessive
wear to the sliding block and lead screw.
tools needed Qty
hex Wrench 6mm .............................................. 1
hex Wrench 5mm .............................................. 1
to adjust the cross slide backlash:
1. Feed the cross slide backwards (toward the
front of the machine) until it reaches the end
of its travel.
2. remove the cap screw that secures the cross
slide leadscrew nut (see figure 87).
figure 87. location of cap screw that secures
the leadscrew nut.
Cap screw securing
leadscrew nut
3. rotate the cross slide handle to feed the
leadscrew nut out from under the cross slide
as shown in
figure 88.