Grizzly Gear-Head G9036 - Manual (Page 23)

Model g9036 Mfg. 7/08+
-21-
tailstock handwheel
turning the tailstock handwheel ( figure 18)
advances or retracts the barrel in the tailstock.
the graduated dial on the handwheel is adjust-
able.
Quill lock lever
the quill lock lever ( figure 18) locks the tailstock
quill in place.
tailstock lock lever
the tailstock lock lever ( figure 18) locks the
tailstock in place on the lathe bed.
figure 18. tailstock controls.
Quill lock
lever
tailstock
handwheel
tailstock
lock lever
figure 17. Carriage lever controls.
spindle lever
the spindle lever (figure 17) is primarily used to
start and stop the spindle and leadscrew in either
the forward or reverse directions.
feed change lever
the feed change lever ( figure 17) allows you to
select which slide will operate with power feed.
the lever pivots through two stops that require
moving the lever left and right as well as up and
down in order to engage the different components.
Moving this lever upward selects power feed for
the carriage. Moving the lever down selects power
feed for the cross slide.
half nut lever
the half nut lever ( figure 17) opens and closes
the half nut on the longitudinal leadscrew, which
engages the carriage power feed for threading.
half nut
lever
Feed Change
lever
spindle lever