Grizzly G0503 - Manual (Page 22)

Model G0503 (Mfg. Since 12/08) -20-
Installing the
Blade cover
Tools Needed Qty
wrench/socket 10mm ...................................... 1
Hardware Needed Qty
Carriage Bolt M6-1.0 x 16 .................................. 4
Flat washer 6mm .............................................. 4
lock nut M6-1.0 ................................................ 4
To attach the blade cover:
1. line up the holes in the blade cover with the
holes in the blade housing.
2. drop the carriage bolts into the holes indi-
cated in figure 12.
3. open the wheel cover to access the carriage
bolts.
4. place the washers and lock nuts on the car-
riage bolts and tighten.
figure 12. the blade cover.
Attaching the
Handwheel Handle
Tools Needed Qty
wrench/socket 19mm ...................................... 1
Hardware Needed Qty
handwheel handle ............................................ 1
To attach the handwheel handle:
1. remove the nut and washer from the
handwheel handle.
2. slide the handle shaft through the hole in the
head elevation handwheel .
3. place the lock washer on the shaft and
thread on the nut.
4. hold the handle stationary and tighten the
nut with the 19mm wrench.
figure 13. head elevation handwheel.