Grizzly Model G8027 - Manual (Page 14)

-12- G8027 1 HP Dust Collector
Components and Hardware Needed: Qty
Motor/Impeller Housing ......................................1
Collector .............................................................1
Base ...................................................................1
Rubber Gasket ...................................................1
Swivel Casters ....................................................4
Collection Bag Support Rods ............................ 2
Upper Bag Support Rod .....................................1
Impeller Housing Support ...................................1
Hex Bolts M6-1 x 15 ......................................... 6
Hex Bolts M8-1.25 x 15 ......................................8
Hex Nuts M5-.8 ................................................18
Hex Nuts M8-1.25 ..............................................4
Flat Washers 5mm ...........................................22
Flat Washers 8mm ...........................................12
Phillips Head Screws M5-.8 x 15 ...................... 6
Phillips Head Screws M5-.8 x 10 .................... 16
Phillips Head Screws M4-.7 x 8 ........................ 2
To assemble the dust collector base:
1. Make sure the dust collector motor is
unplugged!
2. Install the swivel casters onto the base with
sixteen M5-.8 x 10 Phillips head screws,
nuts, and flat washers (see
Figure 5).
Figure 5. Installing casters.
Figure 7. Installing motor/impeller housing on
collector support.
Base and Supports
Figure 6. Installing collector support.
3. Place the base right side up and install the
collector support ( Figure 6) using four M8-
1.25 x 15 hex bolts and four flat washers.
4. Place the motor/impeller housing onto the
collector support plate and fasten with four
M8-1.25 x 15 hex bolts, four hex nuts, and
eight flat washers as shown in
Figure 7.