Grizzly Model G8027 - Manual (Page 16)

-14- G8027 1 HP Dust Collector
Collection and
Filtration Bags
Components and Hardware Needed: Qty
Collection Bag ....................................................1
Filtration Bag ......................................................1
Bag Clamps ........................................................2
To install the collection bag:
1. Place the collection bag over the bottom
edge of the collector and secure the bag
clamp as shown in
Figure 12.
Figure 12. Securing collection bag onto collec-
tor.
Wide Foam Strip
To install the filtration bag:
1. Hook the top of the filtration bag onto the
upper bag support rod, slip the filtration bag
over the top of the collector, and secure the
bag clamp. The dust collector should look
similar to
Figure 14 when fully assembled.
Figure 14. Filtration and collection bags
installed.
Figure 13. Correct bag clamp spring position.
2. If belts are not already installed on the col-
lection and filtration bags, thread the cleated
end of each belt through the left hole and out
the right hole of each bag. Make sure cleated
tips face out.
Latch
Springs
Belt
Cleated Tips of Belt
Clamp
3. Bag clamp springs should be located between
the belt and latch ( Figure 13); if not, the bag
clamp will not work. Adjust the springs if
needed.