Grizzly Model G8027 - Manual (Page 15)

G8027 1 HP Dust Collector -13-
5. Install the rubber gasket onto the motor/
impeller housing opening.
6. Install the collector onto the motor/impeller
housing with six M6-1 x 15 hex bolts, as
shown in
Figure 8.
Figure 8. Installing collector onto motor/impeller
housing.
Figure 9. Securing collection bag support rods.
8. Install the upper bag support onto the collec-
tor, as shown in Figure 10, using two M4-.7
x 8 Phillips head screws.
7. Secure the two collection bag support rods
to the base plate with four M5-.8 x 15 Phillip
head screws and four flat washers, and to the
collector using two M5-.8 x 15 Phillip head
screws, two flat washers, and two hex nuts
as shown in
Figure 9.
Figure 10. Installing upper bag support.
1. Adjust the two hex bolts located on the col-
lector support plate ( Figure 11) so the bolt
heads press against the motor/impeller hous-
ing.
2. Tighten the hex nuts against the support
Collector Support
Bolts
Figure 11. Adjusting collector support plate
bolts.
Motor/Impeller Housing
Collector