Gefen GEF-3GSDI-16416 - Manual (Page 18)

15
IR REMOTE CONFIGURATION
How to Resolve IR Code Confl icts
In the event that IR commands from other remote controls interfere with the
supplied IR Remote Control unit, changing the IR channel on the IR Remote
Control unit will fi x the problem. The IR Remote Control unit has a bank of DIP
switches used for setting the IR channel.
The DIP switch bank is located underneath the battery cover.
1 2
1 2 1 2
1 2
Remote Channel 2:
Remote Channel 0:
Default Remote Channel 1:
Remote Channel 3:
Exposed DIP Switch
bank between the
battery chambers.
It is important that the IR channel on the Remote Control unit, matches the IR
channel set on the 16x16 3GSDI Matrix. For example, if both DIP switches on
the IR Remote Control unit are set to IR channel 0 (both DIP switches down),
then the 16x16 3GSDI Matrix must also be set to IR channel 0. See page 22 on
how to change the IR channel on the 16x16 3GSDI Matrix.