Grizzly G0719 - Manual (Page 14)

-12-
model g0719 (mfg. since 10/10)
inventory
The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
figure 3. inventory.
A
B
C
d
e
F
g
h
i J
NOTICE
If you cannot find an item on this list, check
the mounting location on the machine or the
packaging materials. Sometimes parts are
pre-installed for shipping, or they become
hidden by packaging materials.
Main inventory (figure 3) Qty
a. sander Assembly ........................................ 1
B. left side panel ........................................... 1
C. right side panel .......................................... 1
D. Upper shelf 16 3 ⁄
4
" x 15 3 ⁄
8
" ............................ 1
E. lower shelf 16" x 18 3 ⁄
8
" ............................... 1
f. rear panel................................................... 1
G. panel and door Assembly ........................... 1
h. miter gauge Assembly ................................ 1
i. Wrench 10 x 13 ........................................... 1
J. Bolt Bag ....................................................... 1
—Flat Washers 5⁄16" ................................. 4
—hex Bolts m8-1.25 x 45 .......................... 4
—hex Nuts 3⁄8"-16 ..................................... 4
—Feet ......................................................... 4
—Flange Bolts m6-1 x 12 ........................... 8
—Carriage Bolts 5⁄16"-18 x 3⁄4" ................. 8
—Flange Nuts 5⁄16"-18 .............................. 8
SUFFOCATION HAZARD!
Keep children and pets away
from plastic bags or packing
materials unpacked with this
machine. Discard immediately.