Grizzly G0719 - Manual (Page 17)

model g0719 (mfg. since 10/10)
-15-
figure 8. door w/panel installation.
figure 9. Foot installation.
assembly
When assembling this machine, we recommend
tightening fasteners with hand tools only. Air or
electric impact tools can easily over-tighten fas-
teners, causing them to dig into the paint or strip
threads
to assemble the cabinet and mount the
machine:
1. Fasten the left and right panels to the rear
panel, as shown in figure 6, using (4) 5 ⁄
16
"-
18 x 3 ⁄
4
" carriage bolts and (4) 5 ⁄
16
"-18 flange
nuts.
figure 6. side and rear panel installation.
2. Fasten the upper and lower shelves, as
shown in figure 7, using (8) m6-1 x 12 flange
bolts.
figure 7. shelf installation.
3. Fasten the panel and door assembly to the
left and right panels, as shown in figure 8,
using (4) 5 ⁄
16
"-18 x 3 ⁄
4
" carriage bolts and (4)
5 ⁄
16
"-18 flange nuts.
4. invert the cabinet, thread the (4) 3 ⁄
8
"-16 hex
nuts onto the feet, and install the feet into the
base, as shown in
figure 9.
5. Adjust the feet to approximately the same
height, then return the cabinet right side up.