Grizzly G0719 - Manual (Page 19)

model g0719 (mfg. since 10/10)
-17-
6. turn the machine OFF.
7. remove the switch disabling key, as shown
in figure 14.
test run
once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
the test run consists of verifying the following:
1) the motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
troubleshooting on page 23.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
to test run the machine:
1. disCoNNeCt mAChiNe From poWer.
2. make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
3. make sure all tools and objects used during
setup are cleared away from the machine.
4. Connect the machine to the power source.
5. Verify that the machine is operating correctly
by turning it ON.
—When operating correctly, the machine will
run smoothly with little or no vibration or
rubbing noises.
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
8. try to turn the start the machine with the
paddle switch.
—if the machine does Not start, the switch
disabling feature is working as designed.
—if the machine does start, immediately
stop the machine. the switch disabling
feature is not working correctly. this safety
feature must work properly before pro-
ceeding with regular operations. Call tech
support for help.
figure 14. removing switch key from paddle
switch.