Grizzly G0719 - Manual (Page 20)

-18-
model g0719 (mfg. since 10/10)
sECtiOn 4: OpEratiOns
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and seek additional training from expe-
rienced machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
to complete a typical sanding operation, the
operator does the following:
1. examines the workpiece to make sure it is
suitable for sanding.
2. Adjusts the table tilt if necessary and locks
the table in place.
3. if necessary, inserts the miter gauge in either
the X-axis or y-axis miter slots, adjusts the
miter gauge to the required sanding angle,
and locks it in place.
4. Wears safety glasses and a respirator.
5. starts the machine and dust collector.
6. holds the workpiece firmly and flatly against
both the table and miter gauge (if used),
pushes the workpiece into or along the sand-
ing disc, and moves it to different locations
to wear the sandpaper evenly and prevent it
from overheating.
7. stops the machine.
Damage to your eyes and lungs could result
from using this machine without proper pro-
tective gear. always wear safety glasses and
a respirator when operating this machine.
to reduce the risk of
serious injury when using
this machine, read and
understand this entire
manual before operating.
NOTICE
if you have never used this type of machine
or equipment before, WE strOnGLy rEC-
OMMEnD that you read books, review
industry trade magazines, or get formal
training before beginning any projects.
regardless of the content in this section,
Grizzly industrial will not be held liable for
accidents caused by lack of training.