Grizzly T10097 - Manual (Page 9)

Model t10097 (Mfg. since 07/08) -9 -
grounding & plug requirements
this machine Must be grounded. in the
event of certain malfunctions or break-
downs, grounding reduces the risk of
electric shock by providing a path of least
resistance for electric current.
this machine is equipped with a power
cord that has an equipment-grounding wire
and a grounded plug (similar to the figure
below). the plug must only be inserted into
a matching receptacle (outlet) that is prop-
erly installed and grounded in accordance
with all local codes and ordinances.
improper connection of the equipment-
grounding wire can result in a risk of
electric shock. the wire with green insu-
lation (with or without yellow stripes) is
the equipment-grounding wire. if repair or
replacement of the power cord or plug is
necessary, do not connect the equipment-
grounding wire to a live (current carrying)
terminal.
Check with a qualified electrician or ser-
vice personnel if you do not understand
these grounding requirements, or if you
are in doubt about whether the tool is
properly grounded. if you ever notice that
a cord or plug is damaged or worn, dis-
connect if from power, and immediately
replace it with a new one.
extension cords
We do not recommend using an extension
cord with this machine. if you must use an
extension cord, only use it if absolutely
necessary and only on a temporary basis.
extension cords cause voltage drop, which
may damage electrical components and
shorten motor life. voltage drop increases
as the extension cord size gets longer and
the gauge size gets smaller (higher gauge
numbers indicate smaller sizes).
any extension cord used with this machine
must contain a ground wire, match the
required plug and receptacle, and meet
the following requirements:
minimum gauge size ................. 16 aWg
maximum length ..............................50 ft.
figure 1. typical 5-15 plug and
receptacle.
Grounding Prong
Neutral Hot
5-15 PLUG
GROUNDED
5-15 RECEPTACLE
Serious injury could occur if you connect
the machine to power before completing the
setup process. DO NOT connect to power
until instructed later in this manual.
SHOCK HAZARD!
Two-prong outlets do not meet the grounding
requirements for this machine. Do not modify
or use an adapter on the plug provided—if
it will not fit the outlet, have a qualified
electrician install the proper outlet with a
verified ground.