GE DPGT750EC/GC - Manual (Page 21)

– 21 –
Inverter
The inverter board is enclosed in a protective box
mounted on the top panel under the backsplash.
To access and remove the inverter board:
1. Remove the Backsplash .
2. Remove the 2 Phillips head screws that hold
the inverter box in place.
3. Slide the inverter box toward the rear of the
dryer and lift out.
4. Lift the inverter box up. Press the tabs on the
side and gently pry it open
5. Disconnect the wiring from the inverter board.
Remove the inverter.
Membrane Keypanel
The membrane keypanel is attached to the
backsplash and is available only as a complete
assembly.
• When ordering a replacement backsplash, the
part must be ordered as left or right,
depending upon installation.
• The membrane keypanel is connected to the
control board by a ribbon cable.
Membrane Keypanel Test
To test the membrane keypanel, press the
appropriate pad and check for continuity (0
Ω
)
between the following pins:
Pad Pins
Power 1 and 3
My Cycles 1 and 4
Back 2 and 3
Help 2 and 4
Home 1 and 7
Start/Stop 1 and 5
1
2
3
4
5
7
MEMBRANE
RIBBON
1
Note: The number 1 molded on the membrane
connecter is not a pin reference number.