Garmin Rino 130 - Manual (Page 4)

ii
Introduction
FCC Compliance
The Rino 130 complies with Part 15 of the FCC regulations and with Canadian RSS-210
and ICES-003 for Class B digital devices. Operation of this device is subject to the following
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment generates, uses, and can radiate radio frequency energy and may cause
harmful interference to radio communications if not installed and used in accordance with the
instructions. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet that is on a different circuit than the receiver’s
circuit.
• Consult the dealer or an experienced radio/TV technician for help.
The Rino 130 does not contain any user-serviceable parts. Repairs should only be made
by an authorized Garmin service center. Unauthorized repairs or modifications could result in
permanent damage to the equipment and void your warranty and your authority to operate this
device.
Compliance, License, and
Warranty Information