Grizzly G0703 11 - Manual (Page 15)

Model g0703 (Mfg. since 8/09)
-15-
assembly
To assemble your dust collector, do these
steps:
1. invert the stand, place one 3 ⁄
8
" lock washer
on four caster wheel studs, and thread each
caster stud into the stand (
figure 7).
2. Using a 3 ⁄
8
" wrench, tighten each caster stud.
figure 10. dust collector and stand positioning.
6. position the stand onto the dust collector
housing, and install one 5 ⁄
16
"-18 x 1 1 ⁄
2
" hex bolt
and flat washer on each side of the stand at
the to serve as pivot bolts (see
figure 9 for
location).
7. Using a 5 ⁄
16
" wrench, snug both hex bolts.
figure 9. installing stand.
pivot Bolt location on Both Sides
8. With the help of an assistant, lift up on the
stand and rotate the dust collector into place
where the other six mounting holes line up
with the stand as shown in
figure 10.
9. install the remaining six 5 ⁄
16
"-18 x 1 1 ⁄
2
" hex
bolts and 5 ⁄
16
" flat washers, and tighten all
hex bolts.
figure 7. Stand and caster wheels.
3. rotate the stand to the upright position.
4. Using the h-supports, (16) 5 ⁄
16
"-18 x 3 ⁄
4
" hex
bolts, and 5 ⁄
16
" flat washers; install the upper
rails onto the stand, as shown in figure 8.
5. Using a 5 ⁄
16
" wrench, tighten the hex bolts.
figure 8. installing stand rails.
h-Support
three holes
on
Both Sides