Grizzly G0703 11 - Manual (Page 18)

-18-
Model g0703 (Mfg. since 8/09)
19. place the drum lid onto the drum, and roll
the drum under the cyclone port so the drum
spout is facing toward the dust collector, as
illustrated in
figure 20.
figure 20. Collection drum positioning.
Spout
drum
lid
figure 21. hose and bag installed.
21. Connect the other end of both hoses to the
cyclone housing ( figure 21), and secure
them in place with the appropriate diameter
hose clamps.
22. install the filter element dust bag (figure 21)
to the filter, and clamp it in place with the
spring clamp.
Note: To make filter-element bag installation
easier, you can use a piece of tape to hold
the bag in place while the clamp is positioned
and tightened.
23. Fasten one end of the ground wire (figure
21) to the copper screw in the drum lid and
the other end to the stand using one of the
existing stand
5 ⁄
16
"-18 hex bolts.
20. Connect one end of the 1" hose and the 7"
hose to the collection drum ( figure 21).
ground
Wire
figure 19. Bag installation.
18. install the dust collection bag into the collec-
tion drum as illustrated in figure 19.