Grizzly G0703 11 - Manual (Page 19)

Model g0703 (Mfg. since 8/09)
-19-
5. press the on/oFF button to turn the machine
ON. Make sure your hand stays poised over
the switch in case you need to quickly turn
the machine
OFF.
6. listen to and watch for abnormal noises or
actions. the machine should run smoothly
with little or no vibration or rubbing noises.
— if you suspect any problems, immedi-
ately turn the machine OFF and discon-
nect the machine from power. refer to
Troubleshooting on Page 28 to identify
and fix any problems.
—if you do not solve the problem with the
use of the Troubleshooting guide, contact
our tech Support at (570) 546-9663 for
assistance.
7. press the tiMEr button on the control box
and cycle through each of the times to make
sure the indicators light.
8. press the tiMEr button on the remote con-
trol and cycle through the times in the same
manner as
Step 7.
9. toggle the on/oFF button on both the con-
trol box and the remote control to make sure
they are working properly.
figure 22. Controls.
Test Run
When the assembly is complete, test run your
dust collection system to make sure it operates
properly.
if, during the test run, you do not easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on Page 28.
if you still do not remedy a problem, contact our
tech Support at (570) 546-9663 for assistance.
To test run your dust collection system, do
these steps:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. review Circuit Requirements on Page
11 and connect the machine to the power
source.
4. push the start button to start the dust collec-
tor (see figure 22).
if using a 20-amp, 110-volt power supply
circuit instead of a 30-amp, 110-volt or a
15-amp, 220-volt circuit, the machine may
cause the power supply circuit breaker
to trip. if this occurs, you must install the
included 6" x 5" inlet restrictor to lower
motor load and current draw.
NOTICE