Notice, Power connection – Grizzly 1 1/2 HP Cyclone G0703 User Manual
Page 24
-22-
Model g0703/g0703p (Mfg. Since 3/12)
NOTICE
the model g0703/g0703p is prewired for
110v. if you plan to operate the machine at
220v, the motor must be rewired (see page
12) and a 220v switch must be installed.
power connection
After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.
connecting power
figure 28.
Connecting power.
1. Turn the machine power switch OFF.
2. Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
disconnecting power
figure 29.
Disconnecting power.
1. Turn the machine power switch OFF.
2. Grasp the molded plug and pull it completely
out of the receptacle. Do not pull by the cord
as this may damage the wires inside.