Grizzly 1 1/2 HP Cyclone G0703 - Manual (Page 25)

Model g0703/g0703p (Mfg. Since 3/12)
-23-
test run
When the assembly is complete, test run your
dust collection system to make sure it operates
properly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
troubleshooting on page 40.
if you still cannot remedy a problem, contact our
tech Support at (570) 546-9663 for assistance.
to test run your dust collection system:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. review power supply on page 10 and con-
nect the machine to the power source.
if using a 20-amp, 110-volt power supply
circuit, the machine may cause the power
supply circuit breaker to trip. if this occurs,
you must install the included 6" x 5" inlet
restrictor to lower the motor load and cur-
rent draw.
NOTICE
4. toggle the power switch (see figure 30) to
on (|). the power indicator light will illumi-
nate.
5. press the on/oFF button to turn the machine
ON. Make sure your hand stays poised over
the switch in case you need to quickly turn
the machine
OFF.
6. listen to and watch for abnormal noises or
actions. the machine should run smoothly
with little or no vibration or rubbing noises.
— if you suspect any problems, immediately
turn the machine OFF and disconnect it
from power. refer to troubleshooting on
page 40 to identify and fix any problems. if
you do not solve the problem with the use
of the
troubleshooting guide, contact our
tech Support at (570) 546-9663 for assis-
tance.
7. press the tiMEr button on the remote con-
trol receiver and cycle through each time set-
ting (1, 2, 4, and 8 hours) to make sure the
indicators light.
8. press the tiME button on the remote control
and cycle through the remaining times (9–15
hours) in the same manner as
step 7.
9. to turn the machine OFF, toggle the power
switch to oFF (o) on the receiver or press
the StArt/Stop button on the remote con-
trol.
figure 30. g0703p controls.
power
Switch
on/off
Button
timer
Button
remote Control
ir Sensor