Grizzly 1 1/2 HP Cyclone G0703 - Manual (Page 36)

-34-
Model g0703/g0703p (Mfg. Since 3/12)
remote control
operation
A remote control receiver and handheld control-
ler (see
figure 51) allow the dust collector to be
turned ON and OFF from across the room up to
75-feet away, providing that direct line-of-sight is
maintained.
the Model g0703/g0703p is equipped with a
circuit breaker/thermal overload button. if the dust
collector experiences an overload, this button
pops out and the machine shuts down.
to restart the machine, you must first fix the cause
of the overload, press the circuit breaker/thermal
overload button, then turn the power switch
OFF,
then ON to reset the thermal overload.
figure 51. remote control receiver and
handheld features.
remote
receiver
Controller
to prevent accidental startups by other common
rF items like garage door openers, the remote
control signal for the Model g0703/g0703p is ir
(infrared) rather than a rF (radio frequency) sig-
nal. the remote control switch features a factory-
set 256-code channel setting, which prevents the
simultaneous startup of two g0703p's.
to reprogram the remote receiver:
1. press and hold the SEt button on the remote
control panel (see figure 52 on page 35)
until the SignAl indicator light starts to flash
on the receiver.
2. While the SignAl light flashes, press the
SEt button on the handheld controller to
complete the setting.
this procedure covers how to reprogram the
remote receiver to accept a new remote fre-
quency from the handheld controller. Use these
instructions if you ever replace the two AA batter-
ies in the handheld controller or if the controller
cannot be activated.
reprogramming receiver
Circuit
Breaker/
thermal
overload
power
Switch