Grizzly H7760 - Manual (Page 12)

-10-
H7760 2" x 27" Belt Sander & 6" Grinder
SECTION 3: SET UP
Unpacking
The Model H7760 is shipped from the manufac-
turer in a carefully packed carton.
If you discover
the machine is damaged after you have signed
for delivery, please immediately call Customer
Service at (570) 546-9663 for advice.
Save the containers and all packing materials for
possible inspection by the carrier or its agent.
Otherwise, filing a freight claim can be difficult.
When you are completely satisfied with the con-
dition of your shipment, you should inventory the
contents.
Some metal parts may
have sharp edges on
them after they are
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.
NOTICE
A full parts list and breakdown can be found
toward the end of this manual. For easier
assembly, or to identify specific parts, please
refer to the detailed illustrations at the end of
the manual.
Inventory
After all the parts have been removed from the
carton, you should have the parts shown in
Figure 4:
Inventory Qty
A. Spark Guard ............................................... 1
B. Wheel Dressing Tool .................................. 1
C. Eye Shield & Bracket ................................. 1
D. Tool Rests .................................................. 2
E. Grinder/Sander Unit ................................... 1
F. Hardware Bag ............................................ 1
—Knob Bolt M5-0.8 .................................... 2
—Flat Washer 5mm ................................... 2
—Hex Nut M5-0.8 ...................................... 2
—Flat Washer 8mm ................................... 1
—Hex Bolt M8-1.25 .................................... 1
—Support Arm Bracket .............................. 1
Figure 4. Model H7760 inventory.
B
D
C
E
F
A