Sanding – Grizzly H7760 User Manual

Page 21

Advertising
background image

H7760 2" x 27" Belt Sander & 6" Grinder

-19-

The 2" sanding belt on the Model H7760 works
great for non-ferrous metals and wood products.
A wide variety of belts are also available for many
types of materials and stages of finishing.

The sanding belt will remove large amounts

of material quickly, including your skin. DO

NOT touch the sanding belt and always

position your hands so they will not slip into

the belt or get caught in the belt.

6. Remove your workpiece regularly to check the

progress the sander has made. Remember—
you can always remove more material but
you cannot add it!

7. When you are finished sanding, move the

red switch to the

OFF position. DO NOT con-

tinue sanding and DO NOT manually stop the
sanding belt with your workpiece!

Figure 14. Sanding a workpiece.

Figure 15. Sanding a workpiece.

Figure 13. Examples of tool rest angles.

To sand a workpiece:

1. Before starting the machine, adjust the angle

of the tool rest so your workpiece can be
properly supported and the area you wish to
sand will be parallel with the sanding belt as
illustrated in

Figure 13.

4. Grasp the workpiece tightly and properly sup-

port it on the tool rest.

5. Press the workpiece evenly against the sand-

ing belt with light pressure (see

Figures 14

and 15). DO NOT press hard—let the rota-
tion of the belt do the work

Sanding

2. With the machine plugged into power, stand

to the side of the grinding wheel, and move
the red switch to the

ON position.

3. Allow the machine to run for at least 1 full

minute to make sure that the grinding wheel
is not going to fly apart and injure you, then
move to the front of the machine.

Advertising