Grizzly G9744Z - Manual (Page 15)

G9744Z Metal Cutting Bandsaw
-13-
Inventory
After all the parts have been removed from the
crate, you should have the following items:
Box 1: (Figure 4) Qty
A. Model G9744Z Bandsaw ............................ 1
Hardware and Tools (Not Shown)
•
Chip Tray .................................................... 1
• Triangle Screw 5/16-18 x 3/4" .................... 1
• Flat Washer 5/16" ....................................... 1
• Hex Nut 5/16-18 ......................................... 1
• Hex Bolts M12-1.75 x 50 (Leveling) ........... 4
• Hex Nuts M12-1.75 (Leveling) ................... 4
• Handwheel ................................................. 1
• Handwheel Handle ..................................... 1
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi-
ency, replacements can be obtained at your local
hardware store.
Figure 4. G9744Z inventory.
A
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss-
ing.