Grizzly G9744Z - Manual (Page 20)

-18-
G9744Z Metal Cutting Bandsaw
Chip Tray
Components and Hardware Needed: Qty
Chip Tray ........................................................... 1
The chip tray fits over the lip of the base as illus-
trated in
Figure 10.
Figure 10. Chip tray installed.
Figure 11. Feed stop.
Jam Nut
Feed Stop
Feed Stop
Depending on how the Model G9744Z was
shipped, it may be necessary to adjust the feed
stop before the test run. The blade should not
make contact with any part of the vise assembly.
To adjust the feed stop bolt:
1. Adjust the feed stop bolt and jam nut (Figure
11), so the bandsaw blade teeth are just
below the vise table surface when the cut is
complete.