Grizzly G0601 - Manual (Page 24)

-22-
Model g0442/g0601 (Mfg since 3/12)
4. Attach the cyclone funnel to the intake barrel
with a barrel gasket between them, as shown
in
figure 13, with (12) 5 ⁄
16
"-18 x 1" hex bolts,
(24) 5 ⁄
16
" flat washers, and (12) 5 ⁄
16
"-18 hex
nuts.
note: At the places where you see three
holes close together as shown in
Figure 14,
only use the center hole for this step. The two
outside holes will be used in the next step.
5. Attach the collector mounting brackets to
the intake assembly, as shown in figure 14,
using (8) 5 ⁄
16
"-18 x 1" hex bolts, (16) 5 ⁄
16
" flat
washers, and (8) 5 ⁄
16
"-18 lock nuts.
figure 13. Cyclone funnel attached to intake
barrel.
Barrel gasket
here
x 12
6. place a large piece of cardboard on the
ground to prevent scraping the parts on the
bare floor during the next steps.
7. With the help of another person, lay the stand
assembly on its side on the cardboard and
slide the collector assembly into the stand
assembly, as shown in
figure 15.
8. Fasten the collector assembly to the stand
with (8) 3 ⁄
8
"-16 x 3 ⁄
4
" hex bolts, (16) 3 ⁄
8
" flat
washers, and (8) 3 ⁄
8
"-16 lock nuts, as shown
in figure 15.
9. Attach the 3 x 6mm foam tape on the intake
cylinder, as shown in figure 16.
figure 15. Collector assembly fastened to the
stand.
x 8
figure 16. Foam tape attached to the intake
cylinder.
figure 14. Collector mounting brackets attached
to intake assembly (collector shown upside down
in this photo).
x 8