Grizzly G0601 - Manual (Page 26)

-24-
Model g0442/g0601 (Mfg since 3/12)
14. Attach the assembly to the intake barrel, as
shown in figure 20, with (12) 5 ⁄
16
"-18 x 3 ⁄
4
"
hex bolts and (12) 5 ⁄
16
" flat washers.
figure 20. securing blower on intake barrel.
x 12
15. place the outlet gasket between the motor/
blower housing and outlet port, then attach
the outlet port and filter L-braces to the hous-
ing, as shown in
figure 21, using (10) 5 ⁄
16
"-18
x 1" hex bolts, (20) 5 ⁄
16
" flat washers, and (10)
5 ⁄
16
"-18 hex nuts.
figure 21. Attaching the outlet ports and filter
L-braces to the blower housing.
x 10
outlet
gasket
here
Foam tape
here
16. Attach one roll of 3 x 15 x 700mm foam tape
to the outside lip of each outlet port, as shown
in
figure 21.
17. Attach the two filter cross braces to the
L-braces, as shown in figure 22, using (4)
3 ⁄
8
"-16 x 3 ⁄
4
" hex bolts, (8) 3 ⁄
8
" flat washers, and
(4) 3 ⁄
8
"-16 hex nuts.
figure 22. Attaching filter cross braces to
L-braces.
x 4
figure 23. Cyclone vacuum tube and hose
attachment.
vacuum port
18. Apply the 3 x 6 x 300mm foam tape to the
mating surface of the cyclone vacuum port,
then attach it to the cyclone funnel with (4)
5 ⁄
16
"-18 x 3 ⁄
4
" hex bolts and (4) 5 ⁄
16
" flat washers
(see figure 23).