Grizzly G0456 - Manual (Page 11)

G0456 Variable Speed Wood Lathe
-9-
Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
220V Single-Phase Grounding
In the event of an electrical short, grounding
reduces the risk of electric shock. The grounding
wire in the power cord must be properly connect-
ed to the grounding prong on the plug; likewise,
the outlet must be properly installed and ground-
ed. All electrical connections must be made in
accordance with local codes and ordinances.
Amperage Draw
The Model G0456 motor draws the following
amps under maximum load:
Amperage Draw at 220V .................... 10.5 Amps
Circuit Requirements
Whether you have a dedicated or shared circuit,
ONLY connect your machine to a circuit with
a verified ground, correctly sized wiring, and a
properly rated circuit breaker. Obey all applicable
safety and electrical codes, including the National
Electric Code (NEC).
If you are unsure about
any wiring practices, consult a qualified elec-
trician.
Plug/Receptacle Type
Recommended Plug/Receptacle .......NEMA 6-15
SECTION 2: CIRCUIT REQUIREMENTS
Electrocution or fire could
result if this machine is
not grounded correctly
or if your electrical con-
figuration does not com-
ply with local and state
codes. Ensure compliance
by checking with a quali-
fied electrician!
Extension Cords
We do not recommend the use of extension
cords. Instead, arrange the placement of your
equipment and the installed wiring to eliminate
the need for extension cords.
If you find it absolutely necessary to use an
extension cord at 220V with your machine:
• Use at least a 14 gauge cord that does not
exceed 50 feet in length!
• The extension cord must also contain a
ground wire and plug pin.
• A qualified electrician MUST size cords over
50 feet long to prevent motor damage.
Figure 2. NEMA 6-15 plug and receptacle.