Grizzly G0456 - Manual (Page 37)

G0456 Variable Speed Wood Lathe
-35-
When the table tilt is set to 0˚, the table should be
adjusted perpendicular to the sanding disc face.
Tools Needed Qty
Try-Square or Machinist's Square ..................... 1
To adjust table tilt:
1. Using a try-square or machinist’s square,
set one edge on the table surface and the
other against the face of the disc as shown in
Figure 51. Note: This can be done with the
sandpaper installed, although it is somewhat
easier to measure if the disc does not have
the sandpaper disc installed.
Figure 51. Squaring table to disc.
Table Tilt
Figure 52. Adjusting table tilt indicator.
2. Loosen the lock lever, adjust the table angle
square with the disc, and tighten the lock
lever.
3. Adjust the indicator line over the 0° mark by
loosening/tightening the mounting screw, as
shown in
Figure 52.
The table must be aligned to the face of the
sanding disc so that the sandpaper does not rub
against the table.
To align the table:
1. Loosen the table mount bolts (Figure 53)
that secure the table to the table support
bracket.
Aligning Table
Figure 53. Table mount bolts.
Table
Mount
Bolts