Grizzly G0456 - Manual (Page 16)

-14-
G0456 Variable Speed Wood Lathe
Sanding Table
Components and Hardware Needed: Qty
Sanding Table .................................................... 1
Table Brackets ................................................... 2
Dust Port ........................................................... 1
Lock Handles ................................................... 2
Flat Washers
1 ⁄
4
" (Handles) ............................... 4
Cap Screws 5 ⁄
16
"-18 x 5 ⁄
8
" (Table) ....................... 2
Lock Nuts 5 ⁄
16
"-18 (Table) ................................... 2
Flat Washers 5 ⁄
16
" (Table) .................................. 2
Phillips Head Screws 10-24 x 1 ⁄
2
" (Dust Port) ... 2
Lock Washers #10 (Dust Port) .......................... 2
To install the sanding table:
1. Mount the dust port to the casting with the
Phillips screws and lock washers.
2. Mount the table to the casting with the cap
screws, flat washers, and lock nuts through
the hinge hole; and with the lock handles
and lock washers through the slotted hole.
Figure 7 shows the table properly installed.
Figure 7. Table and dust port properly installed.
Tool Rest
The tool rest can be installed with or without the
tool rest extension. Either component installs by
sliding the shaft into the hole, then tightening it
in position with the lock handles.
Figure 8 shows
the tool rest installed in the base by itself, and
Figure 9 shows the tool rest extension installed.
Figure 8. Tool rest properly installed.
Lock Handle
Figure 9. Tool rest extension installed.