GE 25860 - Manual (Page 14)

14
Leaving a Memo
Use the memo feature to leave a message.
1. Press and hold the memo button on the base. You must hold the button
until you finish recording the memo.
2. Begin speaking after you hear the beep.
3. Release the memo button when finished.
Telephone Set Up
Programmable Menus
There are four programmable menus available on the handset: Language,
Local Area Code, Ringer Tone and Factory Default. When you program
these settings, make sure the phone is OFF ( not in talk mode).
Display Language
1. Press the flash/prog button on the handset until 1 ENG 2 FRA 3 ESP
shows in the display.
2. Use the CID-VOL (- or +) buttons on the handset or the handset touch-
tone pad to select 1, 2, or 3.
3. Press the flash/prog button again.
NOTE: Press the *exit button once to keep the previous setting and return to
the standby screen.
Local Area Code
1. Press the flash/prog button until AREA CODE - - - shows in the display.
The default is - - -.
2. Use the handset touch-tone pad to enter the area code.
3. Press the flash/prog button again.
NOTE: Press the *exit button once to keep the previous setting and return to
the standby screen.
NOTE: To restore the default setting to “- - -” , press and release del/chan
when “AREA CODE” shows in the display.
Ringer Tone
1. Press the flash/prog button until RINGER TONE > 1 shows in the display.
The default ringer tone is 1.