GE 25860 - Manual (Page 20)

20
NOTE: If the memory location is occupied, “REPLACE MEMO?” is displayed,
and you must confirm replacement by pressing the memory button. If you do
not want to replace number in memory location, press the *exit button.
NOTE: It is necessary to format number prior to saving into memory location
because you cannot format number after it is saved.
Storing a Redial Number
1. Make sure the phone is OFF (not in TALK mode).
2. Press the memory button on the handset.
3. Press any number key (0-9) on the handset to store the phone number in
that memory location.
4. Press memory again, and ENTER NAME shows on the display.
5. Use the handset touch-tone pad to enter the caller’s name (see step 4 in
Storing A Name and Number in Memory), and then press memory again.
ENTER TEL NUMBR displays.
6. Press redial on the handset to display the redial number and name.
7. Press memory again to confirm.
NOTE: If the redial number has more than 24 digits, the redial number
cannot be stored in memory.
To replace an old redial number stored in a memory location with a new
redial number:
1. Repeat steps 1 through 5, then press redial to display the new redial
number and name.
2. Press memory again, and REPLACE MEMO? shows in the display.
3. Press the memory button to confirm replacement.
NOTE: If you do not want to replace number in memory location, press the *exit button.
Dialing a CID Number
1. Make sure the phone is OFF (not in TALK mode).
2. Use the CID-VOL (- or +) buttons on the handset to display the desired
CID record.
3. Press the talk/callback button on the handset to automatically dial the
phone number in the record.