Grizzly T10222 - Manual (Page 11)

Model t10222 (Mfg. since 12/09)
-9-
Assembly
the Model t10222 mounts on most table saws
that have 27" deep tables. if your table saw does
not have mounting holes for the installation of the
router table, you will need to drill and tap these
holes. Also, you may have to modify the fence
rails to allow access for the router table t-slots.
read this entire assembly section before begin-
ning the installation procedure below to make
sure the t10222 will fit your table saw.
To assemble and install your router table
attachment:
1. disConnECt thE tABlE sAW FroM
poWEr!
2. decide which of the following mounting
options best suits your needs:
— remove the existing right wing of the saw
table and use the existing wing mounting
holes to attach the router table.
— Mount the router table to the right side of
the saw table or the existing right-hand
wing. in these cases, you will probably
need to drill and tap three M8-1.25 holes
into the saw table or wing that match those
in the router table (see
figure 6).
Tip: Use the holes in the router table as a
template for marking the mounting hole loca-
tions on the saw table so that the router table
top will mount flush with the top of the saw
table.
figure 6. required mounting holes in the router
and saw tables.
saw table
router table
Mounting holes
3. thread the foot pad assembly into the bottom
of the support leg, as shown in figure 7. For
now, do not tighten the jam nut up to the leg
so that you can adjust the height of the leg in
a later step.
figure 7. Foot pad threaded into the support leg.
Jam nut
support
leg
Foot pad