Grizzly T10222 - Manual (Page 14)

-12-
Model t10222 (Mfg. since 12/09)
DO NOT operate the attached router without
an adequate dust collection system. follow
your router manufacturer's specifications for
the required dust collection capacity. failure
to use a dust collection system can result in
short and long-term respiratory illness.
11. Attach the dust port to the back of the fence
assembly with the (4) M6-1 x 10 cap screws
and (4) 6mm flat washers, as shown in
figure 16.
figure 16. dust port installed.
dust port
12. slide the attached square nut on the guard
bracket into the top fence t-slot, center it with
the dust hood and dust port, then tighten the
cap screw to secure it in place, as shown in
figure 17.
figure 17. guard bracket attached to the fence.
guard Bracket
To reduce the risk of hand injury from acci-
dental contact with the spinning router bit,
ALWAyS make sure the fence and router
guard are properly positioned and secured
before connecting the router to power—the
exception is free-hand routing.
13. Attach the plastic router guard to the guard
bracket with the (2) star knob bolts, as shown
in
figure 18.
figure 18. router guard installed.
router guard
star Knobs