Grizzly T10222 - Manual (Page 15)

Model t10222 (Mfg. since 12/09)
-13-
Router installation
the Model t10222 will support a router with a
base thickness between
1 ⁄
4
" and 2 1 ⁄
4
".
To install a router:
1. disConnECt thE sAW And routEr
FroM poWEr!
2. slide three of the router hold-down assem-
blies into the t-slots underneath the router
table so that they allow room for the router
base, as shown in
figure 19.
Note: To properly position the hold-down
clamp, adjust the tightness of the hold-down
knob and the adjustment bolt so that the
clamp will allow room for the router base in
the next step. If necessary, put the adjust-
ment bolt jam nut on the other side of the
clamp.
figure 19. router hold-down assembly controls.
router
Clamp
Adjustment
Bolt
hold-down
Knob
If the router unexpectedly moves or the rout-
er bit contacts the table insert or fence dur-
ing operation, serious personal injury could
result from flying debris. ALWAyS make sure
that all four router clamps are used and are
applied to the flat surface of the router base
before connecting the router to power.
3. slide the router base onto the three hold-
down clamps, position them so that they
secure the router bit in the center of the table
opening, then tighten the hold-down knobs
and adjustment bolts to secure the router in
place (see
figure 20).
4. install the remaining hold-down assembly to
make sure the router stays firmly in place dur-
ing operation.
figure 20. router installed in the hold-downs.
NOTICE
To prevent dam-
age to the router
table T-slots, do not
position the clamp
adjustment bolts
over the thin edge of
the T-slots.