Grizzly G0717 - Manual (Page 24)

-22-
Model g0717 (Mfg. since 9/10)
sECtiOn 4: OpERatiOns
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and seek additional training from expe-
rienced machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
Damage to your eyes and lungs could result
from using this machine without proper pro-
tective gear. always wear safety glasses and
a respirator when operating this machine.
to reduce the risk of
serious injury when using
this machine, read and
understand this entire
manual before operating.
NOTICE
if you have never used this type of machine or
equipment before, wE stROnGLy RECOM-
MEnD that you read books, review industry
trade magazines, or get formal training before
beginning any projects. Regardless of the
content in this section, Grizzly industrial will
not be held liable for accidents caused by
lack of training.
to complete a typical cutting operation, the
operator does the following:
1. examines the workpiece to make sure it is
suitable for cutting.
2. raises the headstock, then closes the
downfeed valve.
3. adjusts the headstock angle for the type of
cut, then securely clamps the workpiece in
the vise.
4. adjusts the guides as close as possible to the
workpiece without contacting it, and verifies
that the blade is properly tensioned.
5. adjusts the downfeed rate adjust knob for the
correct feed rate.
6. Makes sure the workpiece and bandsaw are
stable and that there are no obstructions in
the way of the cut.
7. puts on safety glasses.
8. starts the bandsaw and waits for the blade to
reach full speed.
9. opens the downfeed valve to lower the head
and blade into the workpiece, then allows the
bandsaw to complete the cut.
10. once the bandsaw has stopped, raises the
head, and removes the workpieces.