Grizzly G0717 - Manual (Page 35)

Model g0717 (Mfg. since 9/10)
-33-
While simple in concept and function, many
issues must be taken into account to find and use
the correct cutting fluid. always follow all product
warnings and contact the fluid manufacturer for
unanswered questions.
use the information below as a guideline to
choose the appropriate cutting fluid. always refer
to the cutting fluid manufacturer for specific appli-
cation and safety information:
• For cutting low alloy, low carbon, and gen-
eral-purpose category metals with a bi-metal
blade —use a water soluble cutting fluid.
• For cutting stainless steels, high carbon, and
high alloy metals, brass, copper and mild
steels—use "neat Cutting oil" (commonly
undiluted mineral oils) that have extreme
pressure additives (ep additives).
• For cutting cast iron, cutting fluid is not rec-
ommended.
Remember: Too much flow at the cutting fluid
nozzles will make a mess and can make the work
area unsafe; and not enough fluid at the cut will
heat the blade, causing the blade teeth to load up
and break.
tip: Using a refractometer or hydrometer to
replenish water in water-based coolant can extend
the life of blades and coolant, and ensure consis-
tent cutting results.
Cutting fluid
BiOLOGiCaL anD
pOisOn hazaRD! use
proper personal protection
equipment when
handling cutting fluid
and follow federal, state,
and fluid manufacturer
requirements to properly
dispose of cutting fluid.
the reservoir on this machine is designed
to store cutting fluid. During storage, some
fluids grow dangerous microbes, or due to
the collection of toxic metal chips in the
fluid, the fluid can become a potent and
extremely poisonous solution to humans
and animals.
usE the correct personal protection
equipment when handling cutting fluids to
prevent infections and poisoning.
usE a good bactericide and fungicide for
additional protection.
fOLLOw federal, state, and the fluid
manufacturer requirements to properly
dispose of cutting fluid when it becomes
unsafe.
BiOLOGiCaL and pOisOn
hazaRD!
NOTICE
Clean coolant system with a bactericide and
fungicide between coolant changes to pre-
vent recontamination.