Motorola VT1000 - Manual (Page 24)

18
Connecting a Computer to Display the Configuration Pages
For a Network Installation With Calls Not Prioritized only, you need to connect a
computer with DHCP enabled to the Motorola voice terminal to display the configuration
pages. For information about enabling DHCP, refer to your operating system
documentation.
If you performed an Installation With A Single Computer or a Network Installation With
Calls Prioritized , a computer is already connected to the Motorola voice terminal.
To connect a computer to the back of the Motorola voice terminal:
1 Connect one end of an Ethernet cable to the PC connector on the Motorola voice
terminal.
2 Connect the other end of the Ethernet cable to the Ethernet connector on a
computer.
3 Power up the computer.