Microtek CX4 - Manual (Page 10)

Setting Up The Projector
1. Place the projector on a sturdy, flat surface within 1.8 meters of a computer
or video source (e.g. video tape deck, camcorder, digital camera, or laser
disk player).
2. Place the projector at a qualified distance from the screen so as to project
the desired screen size. Refer to the following chart for suitable distances to
keep.
3. Adjust the projector so as
to parallel the lens at right
angles to the screen. If
the projector is not angled
correctly, the screen
image will be crooked.
4. Connect one end of the
power cable bundled with
this projector to its power connector. Connect the other end to a grounded
electrical socket.
Warning:
Never look into the lens of the projector and never let children look into the
lens of the projector.
HORIZONTAL DISTANCE
BETWEEN THE PROJECTOR
AND THE SCREEN
SCREEN
SIZE
The Shortest
Distance
The Longest
Distance
300” 12.5m 16.5m
200” 8.5m 12.0m
100” 4.5m
6.0m
80” 3.5m 4.5m
60” 2.5m 3.0m
40” 1.5m 2.0m
30” 1.5m
5. To insert the batteries in the remote control device, slide off the battery
compartment cover as shown below.
6. Install two AA type batteries bundle with your packing as the diagram shows.
9