Connecting to a macintosh desktop computer – Microtek CX4 User Manual
Page 15
4.
Connect one end of the USB Cable to the USB port of the projector, and
connect the other end of the USB Cable to the USB port of your computer.
5.
Tighten all connector screws to ensure secure connections.
Connecting To A Macintosh Desktop Computer
Before connecting this projector to a Macintosh desktop computer, make sure that
both machines have the power shut off.
1.
Remove the Mac monitor cable from the Mac.
2.
Set the DIP switches of the Mac Adapter in accordance with the desired
resolutions (i.e. 19” mode).
3.
Then, connect the Computer Cable to one end of the Mac Adapter.
4.
Tighten all connector screws to ensure secure connections.
5.
Connect the other end of the Mac Adapter to the Mac.
6.
Connect the other end of the Computer Cable to the Computer In port of the
projector.
7.
If necessary, connect the Mac monitor to the Computer Out port of the
projector.
If the functions of the wireless mouse on the Remote Control need to be operated,
please make the connections to each signal cable according to the steps
numbered 8 ~ 10 below:
8. Connect
the
Control Cable to the Control port of the projector.
14