Microtek CX4 - Manual (Page 25)

Turning The Equipment On And Off
Turn on the projector and any video players in the following sequence:
1. Video Signal Source equipment
2. Audio Signal Source equipment (If it is different with a computer or video
signal source)
3. Projector
4. External Speaker
5. Computer
Remove the lens cover before the projector is turned on. When the power source
is connected, the Power Led Indicator will first blink for a few seconds and will be
fully lit when the connection of the power source is completed. If the computer and
the Video Signal Source are connected, an image depicting a computer or a Video
Signal Source will be displayed. It will take at least 30 seconds to display a regular
image after the power has been connected.
Warning:
When the lamp is turned on, never let yourself or let children look into the lens of
the projector. The bright light emitted from the lamp into the lens of the projector
will seriously damage the eyes.
Attention:
Remove the lens cover before the projector is turned on as the strong light emitted
from the lamp will damage the lens cover permanently.
To turn the projector and its accessory equipment off, please operate the above
steps in reverse order.
Attention:
When the power source is disconnected, the built-in fan will continue to operate in
order to cool down the projector, and the Power Led indicator will turn orange and
blink for two minutes. When the projector -has cooled down, Power Led indicator
will remain lit in green. If the projector is turned on during Power Led indicator is
blinking in orange, the projector will not be able to display images.
Attention:
24