MITSUBISHI ELECTRIC DX-VS1 - Manual (Page 16)

DX-VS1UE User DX-VS1UE User DX-VS1UE User DX-VS1UE User’’’’s Manual s Manual s Manual s Manual
15
To change the IP address, enter the Administrator’s
password and press “Change IP Addr.”, enter the new IP
address and press “OK.” Button. The “Reboot” button will
reboot the DX-VS1UE. This process takes 10-20 seconds.
・ ・ ・ ・Setting Administrator Conditions
To access the Server Configuration Page in DX-VS1UE
from the Setup Menu, enter the admin’s password and press the “Start Con-
figuration” button. (For more detailed information, refer to Chapter V
“Server Configuration Page”)
* Terminology *
IP Address
IP address is an identification code for computers and devices on a TCP/IP network.
Networks using TCP/IP protocol routes based on the IP address of the destination. IP
addresses can be assigned at random as long as each one is unique on closed net-
work. However, connecting a private network to the Internet requires using regis-
tered IP addresses to avoid duplicates. IP address can be acquired from a network
administrator or an Internet service provider.
MAC Address (Media Access Control Address)
MAC address is a hardware identification code that uniquely identifies each node of a net-
work. The MAC layer directly interfaces with the network media. Consequently, each type
of network media requires a unique MAC layer. The MAC address of DX-VS1UE is com-
posed of 12-digit numbers. A unique MAC address can be found on the label at the bottom
of each DX-VS1UE.
Crossover Cable
The crossover cable (red) provided with the DX-VS1UE is used to connect DX-VS1UE with
a PC. A HUB is not necessary for connecting DX-VS1UE to a PC if a crossover cable is
used.
Straight Cable
The straight cable (white) is used if a HUB is used as an intermediary between DX-VS1UE
and PC.